pelantar

Online Bubble Level on Camera

Hold your phone up to a wall, a picture or a shelf and see a live level line over the camera image. A green centre dot marks the zero point and an orange line shows how far the phone is rolled.

Advertisement
Quick answer: Allow the camera, tap Enable sensors and hold the phone upright. The orange line passes through the green centre dot and rotates with the phone, so you can line it up against any edge. At the zero point the bubbles turn green and the phone vibrates if supported.

How to use the level on camera

  1. Start the camera and sensors. Allow camera access, then tap Enable sensors and grant motion access.
  2. Hold the phone upright with the camera facing the surface. The orange line rotates to stay level with the real horizon, and it always crosses the green centre dot.
  3. Compare with the scene. If the orange line is parallel to the edge of a shelf, picture frame or tile course, that edge is level. If it tilts, the number shown tells you by how many degrees.
  4. Adjust the zero point. The default zero is the centre. To change it, hold the phone against something you know is level and tap Zero here, or tap Reset zero to restore the centre.
  5. Feel the result. With Vibrate on, the phone buzzes briefly when the line reaches the zero point.

Why a camera view helps

A plain bubble level tells you about the phone. The camera view lets you compare the real world with a true horizontal line at the same moment. That is useful when you cannot put the phone on the surface, for example when checking a high shelf, a picture rail, a ceiling line or a row of tiles from a distance. The line is drawn from the phone sensor, so it stays level even when the camera image is not.

Getting the best result

  • Hold the phone upright and steady. Rest your elbows against your body to reduce shake.
  • Keep the camera lens square to the wall, because looking up or down at it distorts how edges appear against the line.
  • Zero the level on a surface you trust before an important job.
  • Remove thick cases that sit unevenly.
  • Check twice, flipping the phone 180 degrees. If the two readings agree, the setup is good.

Related tools and guides

For a tilt reading on a surface rather than a camera view, use the bubble level. To turn a measured tilt into a slope for a ramp or roof, read slope explained.

Advertisement

Frequently asked questions

How does the orange line work?

It is drawn from your phone's accelerometer. It rotates against the roll of the phone so it always points along the real horizontal, and it passes through the green centre dot.

What is the green dot?

It is the centre reference for the level line and marks the zero point of the gauge. The yellow bubble moves relative to it, and both turn green when you reach zero.

How do I change the zero point?

Hold the phone against a surface you know is level and tap Zero here. Tap Reset zero to return to the centre.

Why is there no vibration on my iPhone?

iPhone browsers do not allow the web vibration feature. Android browsers usually do.

Is the camera level as accurate as a spirit level?

No. It is accurate to about half a degree after zeroing, which suits shelves and pictures. Use a proper level for structural work.

Why does the line look tilted even though the wall is level?

Perspective. If the camera is angled up or down, edges appear tilted. Hold the phone square to the wall.

Do I need the camera for the level to work?

No. The line is drawn from the motion sensor, but the camera helps you compare it with the scene.

Is anything uploaded?

No. Camera frames and sensor data stay on your device.

Related tools

Online Ruler · Ruler on Camera · Grid Measurement · Grid on Camera · Unit Converter · Online Protractor · Protractor on Camera · Bubble Level · Sound Meter · Tone Generator

Guides

How accurate is a phone bubble level, and how to improve it · Slope explained: degrees, percent, ratio and roof pitch