pelantar

Online Sound Meter

Use your microphone as a quick sound level meter. Start a 20-second test and Pelantar reports the average level, peaks, background noise, the dominant frequency and the nearest musical note.

Advertisement
Quick answer: Tap Start 20 s test and allow the microphone. When the run ends, you get an analysis with the average level (Leq), minimum, maximum, L10 and L90 percentiles, the time spent above 70 and 85 dB, the typical tone and an exposure guide.

How to use the online sound meter

  1. Start the test. Tap Start 20 s test and allow microphone access. The page records for exactly 20 seconds, then stops.
  2. Hold the device steady. Keep the microphone pointing at the source, about an arm's length away, and avoid touching the phone.
  3. Watch the live display. The spectrum shows which frequencies are loud, and the line chart shows the level history.
  4. Read the analysis. When the run finishes, the results panel lists the numbers explained below. Tap Run again to repeat.
  5. Adjust the offset. In Settings you can add or subtract up to 30 dB if you have a reference meter to compare against.

What the analysis tells you

  • Leq (average level). The steady level that carries the same sound energy as the whole run. This is the best single figure for noise.
  • Min, max and median. The quietest and loudest moments and the middle value.
  • L10 and L90. Level exceeded 10% and 90% of the time. L10 reflects the peaks and L90 the background noise.
  • Spread. How much the level varies. A small spread means steady noise such as a fan; a large one means impulsive noise such as hammering or barking.
  • Time above 70 and 85 dB. The share of the run at levels that are noisy or potentially harmful over long periods.
  • Dominant tone. The most common loud frequency, with the nearest musical note.
  • Exposure guide. A rough daily time at the measured level, using the NIOSH 85 dBA and 3 dB rule.

Why a phone is an estimate

Phone microphones are designed for speech, not measurement. Many apply automatic gain control or noise suppression, their sensitivity differs from model to model, and they do not respond equally to all frequencies. Pelantar asks the browser to switch these processes off where possible and reports an unweighted level, but an uncalibrated phone can still be several decibels out, and it cannot measure very quiet or very loud sound reliably. Use it to compare rooms, spot problems and learn, not for compliance. The guide on whether a phone can measure decibels accurately goes into detail.

Tips for a better reading

  • Run the test several times and look at the average.
  • Keep the phone away from walls and your hand, which reflect and block sound.
  • Do not talk during the test unless you want your voice to count.
  • Compare against a reference meter once and use the offset to correct for your phone.
Advertisement

Frequently asked questions

How accurate is an online decibel meter?

A phone gives a useful estimate, often within a few decibels in the middle of its range, but it is not calibrated. Use it for comparison, and a certified meter for official measurements.

What is Leq?

Leq is the equivalent continuous sound level: the steady level that would deliver the same sound energy as the varying noise over the same time.

Why 20 seconds?

A short, fixed run is long enough to catch typical variation while keeping the microphone from running by accident. You can repeat the run as often as you like.

Is my audio recorded or uploaded?

No. The microphone signal is analysed in your browser and discarded. Nothing is stored or sent.

What is a safe noise level?

Public health guidance generally treats levels above about 85 dBA over an 8-hour day as a risk to hearing, and every 3 dB increase halves the safe time.

Why does my reading seem too low or too high?

Every phone microphone is different. Use the Level offset in Settings to match a reference meter.

Can it measure frequency?

Yes. It shows the dominant frequency in hertz and the nearest musical note. For testing speakers, try the tone generator.

Does it work on a computer?

Yes, if the computer has a microphone. Laptop microphones are often less accurate than phone microphones.

Related tools

Online Ruler · Ruler on Camera · Grid Measurement · Grid on Camera · Unit Converter · Online Protractor · Protractor on Camera · Bubble Level · Bubble Level on Camera · Tone Generator

Guides

Can a phone measure decibels accurately? · Noise exposure and hearing safety: how loud is too loud?